I have now tht bok where it reads the zero fighter. I was expecting some mor dimensions and crossections.
Have you got any idea of an other book that could be worth while to buy ? The first book which is no longer been pubished was too expecive.
Ari
Hello,
I would like to buy a book or some buplicationt from where there are measurements for x and y for crossections.
Also tail unit and engine cowling for start then later the wing and tailplane.
Can you addvise as it seems that all a6m books are in Japanees but att least measurements are in...
Dear Shipanski
Thank you for those measurements now i must try to correct all my drawings as it seems
that all is 20.5 mm narrow by one half so totaly 41 mm
Hey,
I also wonder how (tiny) small are the canopy rolers if those fit inside your giving measurements
Yours i think are outside dimenssions. I draw outside measures lik yours and inside as below. Photo
i found from net i can not remember whose.
Ari
Hey, Shinpachi
On your lower drawing section D-D the rail is out of the crossection at the top of rail and how i see it the roller dose not need to
go inwards att all.
Hi,
I notised that you were wondering canopy rail movement.
My a pinion about this matter aftr studing few photographs.
Canopy in sliding straight looked ftom top, from side it goes slightly
downwards.
What comes exes ftom crossection is left behind canopu stringes.
Am i makeing any sense.
I...
Hello,
Shinpaschi
Iam tying to convince you iknow something more...
Canopy rail is straight from up looking, sideways going slightli down.
But fuselage crossection dose not show it as it il left behind canopy stringers
There is no 20mm change to be needed as canopy rols straight...