++ **** DONE: 1/48 P-63C - Military Conflicts of the 1950's (1 Viewer)

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

The PE seat and harness
P9292165.JPG


The cockpit painting and weathering also finished

P9292166.JPG
P9292167.JPG
P9292171.JPG
 
The finished cockpit. the gun sight didn't sag, its supposed to be tilted like that.
P9292175.JPG
P9292178.JPG
P9292182.JPG


Glued into the right fuselage half along with a whole lot of lead nose weight
P9292183.JPG

P9292185.JPG


Fuselage glued together. Took a lot of clamps to make every thing work,but it looks like I'll get away with minimum filler on this joint.

P9292187.JPG
 
Last edited by a moderator:
The wings are now on and all blended in. The second picture shows the most difficult area taking some plastic card, a lot of thick CA and a couple of hours of filing and sanding.

PA142188.JPG

PA142189.JPG
 
Thanks guys

More progress. The fuel tank, bomb and gun pilons put on along with the tail. All the seems have been smoother over and the entire airframe sanded down to 1000 grit paper. Have to decide now weather to go ahead with painting or tackle the vacuformed canopy first.

PA162194.JPG
PA162193.JPG
 
Looking good. In my hunt for sand paper the finest I could find was 800 grit in the 4x9 sheets. Seeing you mention 1000, I did a quick Google and found I've been looking in the wrong department all this time.....off to the automotive department at Canadian Tire the next time I hit PG. Many thanks Glenn
 
Yea George, I got some 1200 around here somewhere and I know I've seen it in 1500 but I think 1000 is enough for a NMF if you use a soft cotton cloth to polish it after. For clear parts though I've got some polishing pads that go up to - if i remember correctly - 12,000 grit, bit lately I've just been using my wife's finger nail polishing sticks for canopys
 

Users who are viewing this thread

Back