GB-63 1/48 Hurricane Mk.I – Stormy Weather

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

,
Yep, the "headrest" part is the head/back armour plate, and should be forward of the half bulkhead at the front of the "doghouse".
Thing is, the cockpit assy has holes in the framework that match Pins on the sidewall of the fuselage. This is the result I got mating these. Not a factor with resin replacement.
Good stuff so Far Bill, and yes, the escape hatch on the starboard side wasn't hinged. It was a "knock out" panel, released by a lever inside and then jettisoned.
I had found this in my search for WT?
Quite a gap on those gun inserts. Have you checked they're the correct orientation, side for side (although it looks like they'll still have gaps.) ?
Over and over, the holes are on the Upper half of the wing, lined up with shell chutes Under. No other way to place them.

I will prevail!!!!!!
 
I have been sneaking in some work, now and then.
Firts my gun shroud cover, some card to fill the gap.
Then used some of my spru slurry to fill some sinking.

Now this resin cockpit, WTAF????? I have already removed about 2mm
from the bottom of the assembly and look at the Bloody gap!!!!!
Wheel well tops inside the fuselage, other arrow is the bottom of c-pit!

Doesn't anyone else have these issues?????????????????????????
 
Well so far I have THIS.............................. the bottom of the cockpit floor!
and I am Still 1mm shy of getting the wing tops to align wit the fuselage!!!
I am getting a bit perturbed by it all....................
 

Users who are viewing this thread