PBY-6A drawing

Discussion in 'Schematics' started by Micdrow, Sep 30, 2007.

Thread Status:
Not open for further replies.
  1. Micdrow

    Micdrow “Archive”
    Staff Member Moderator

    Joined:
    Aug 21, 2006
    Messages:
    7,715
    Likes Received:
    424
    Trophy Points:
    83
    Occupation:
    Manufacture Tech
    Location:
    Wisconsin
    PBY-6A drawing kinda hard to read but is interesting.

    Enjoy
     

    Attached Files:

  2. Micdrow

    Micdrow “Archive”
    Staff Member Moderator

    Joined:
    Aug 21, 2006
    Messages:
    7,715
    Likes Received:
    424
    Trophy Points:
    83
    Occupation:
    Manufacture Tech
    Location:
    Wisconsin
    Some more drawing of different area's.

    Enjoy!!!
     

    Attached Files:

  3. Wuerger190

    Wuerger190 New Member

    Joined:
    Nov 19, 2007
    Messages:
    26
    Likes Received:
    2
    Trophy Points:
    3
    You can find the full E&M manual on WWW.PBY.COM Home Page - if I remember it has a similar drawing as above. Look under Archive.
     
  4. Micdrow

    Micdrow “Archive”
    Staff Member Moderator

    Joined:
    Aug 21, 2006
    Messages:
    7,715
    Likes Received:
    424
    Trophy Points:
    83
    Occupation:
    Manufacture Tech
    Location:
    Wisconsin
    Thanks Wueger190 will have to check these out.
     
  5. sagindragin

    sagindragin New Member

    Joined:
    May 6, 2007
    Messages:
    27
    Likes Received:
    0
    Trophy Points:
    1
    Occupation:
    hgv driver
    Location:
    ellistown
    Home Page:
    hi micdrow,

    nice drawings, but don't trust them for shape, the only good thing on them is the measurements.
     
  6. Micdrow

    Micdrow “Archive”
    Staff Member Moderator

    Joined:
    Aug 21, 2006
    Messages:
    7,715
    Likes Received:
    424
    Trophy Points:
    83
    Occupation:
    Manufacture Tech
    Location:
    Wisconsin
    Thanks John, I will try and remember that. Those drawings came from the austrialan archives if I rember right.
     
  7. sagindragin

    sagindragin New Member

    Joined:
    May 6, 2007
    Messages:
    27
    Likes Received:
    0
    Trophy Points:
    1
    Occupation:
    hgv driver
    Location:
    ellistown
    Home Page:
    no problem my friend,

    trouble is a lot of people think that because these drawings are in an official manaul that they are accurate, they are not, they are best used for the measurements and general arangements, the same for station drawings, with these it is best to draw a line to the scale you want marking of the stations at the correct measurements, then draw the outline over the top checking alll the while that the stations line up with know parts(engine bay, cockpit and fin.

    hope this helps you guys.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page