Primer bleeding through on metal painted surface (1 Viewer)

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

pinehilljoe

Senior Airman
667
463
May 1, 2016
Anyone have suggestions on preventing the issue in the photos? A little off topic, I'm restoring Matchboxes. The car was primed with acrylic metal primer, two days later painted with green paint. All Tamiya acrylics. I've used the same process on other cars. Perhaps I thined the green too much?

The nice part of about Matchboxes is they take relatively little time, scratched and beat up cars are had for a dollar or two, and if you don't like the paint job, just strip and start over.

IMG_4954.JPG
IMG_4953.JPG
 
Last edited by a moderator:
Yep it looks like to much thinned paint. But also it seems that you didn't degrease the surface properly.. I would suggest sanding the areas with these light spots with some of very fine sandpaper. Just a little bit of course and then re-applying of the green colour but not that thinned.
 
I used .5 ml thinner to 1 ml green paint, but with the small amount, its easy to over thin
 
I see. So you have to use more paint for the mixture.
 

Users who are viewing this thread

Back