Small tanks' turret ring diameter? (3 Viewers)

tomo pauk

Creator of Interesting Threads
15,896
5,836
Joined
Apr 3, 2008
The good data about the bigger siblings is relatively easy to find, but it does not seem so for the small tanks, like the M3/M5 lights, Soviet light tanks, Pz-I and -II, the British, Czech, Italian, French and Japanese stuff etc. If anyone has some data, please post here :)
 
The good data about the bigger siblings is relatively easy to find, but it does not seem so for the small tanks, like the M3/M5 lights, Soviet light tanks, Pz-I and -II, the British, Czech, Italian, French and Japanese stuff etc. If anyone has some data, please post here :)
Tomo, perhaps check here:
Light Tank M3 Stuart

it appears that the M3's ring diameter was 46.75" (118.7cm) across all models produced (including cast and forged rings).

Here's AFV Database's homepage:
AFV Database
 
Outside Diameter (OD)?
I ask because I kept the Rotec bearing off the 12 ton excavator that I replaced. It still works and would make a great mockup turret ring. Just needs re-greased and exercised I think.
PXL-20220616-191801313.jpg

It is around 36" and you can get through it OK.
 
For French vehicles. To be as clear as possible, I differentiate:
- OD the outer diameter which is the size of the hole in the vehicle's hull roof to accommodate the complete turret ring mechanism;
- BD the diameter at the ball bearings which is the figure usually given in French documents;
- ID the free inner diameter which is the smallest available diameter inside of the turret ring and a restriction to ergonomics, number of crew and weapon size. Sometimes defined as the "clair (clear)" in French or the "primitive diameter" which is the diameter at the race teeth, when they are the limiting diameter.

Note that the 954mm figure is a standard applied accross Renault, Hotchkiss and AMX light tanks to properly center the turret. 36 FCM is a bit peculiar.

TurretID (mm)BD (mm)OD (mm)Comments
APX-1/4 (D2/Char B)9801070 1070 roof hole/1250 recess
APX-1CE (S35)1130
APX-5 and AVIS (AMR 33/35, AM 39)1050
APX-2/3 (AMC 35 and AMD 35)127013951570 recess/1350 hole
APX-R (R35/40 and H35/39)876954/9571106 recess/954 holeReinforced 36 FCM turret uses same turret ring for compatibility
ARL 2 and 2C (B1 Ter/S40)10821180-ish1248
36 FCM (R35 mounting)924 (race teeth), 884 9791106 recess/954 holeOD 1118 or 1026mm recess and 1000mm hole with FCM mounting
AMX 37mm turret (AMX 38)9129941120 recess/954 hole
AMX 47mm turret (AMX 38 Série)91210541120 recess/954 holeAlso applies to 37mm with MAB turret ring system
ARL 5 (AMX 38)93010301120/954 hole
 
Most excellent :)
The big diameter of the armored cars comes out as a surprise.
 

Users who are viewing this thread

Back