The planned use if there was a plan was just as likely to be based on bombing tents in the middle east.
I was mostly curious how much skill the RAF had with CAS in 1939.
Even with the over optimism about what bombing could achieve I cant see anyone considering that the Battle was going to make any effect bombing cities.
Correction: The RAF seemed to be based predominantly on busting cities/defending against city busting. The idea behind a bomber size treaty was to prevent city busting campaigns and keep bombing relegated to military targets only.
The problems with the wind tunnels may have had nothing to do with the Battle. However. Carrying two 250lbs bombs inside of each wing did.
So, the wings were large to stuff bombs in them? So, your proposal would have been to have redesigned the wings to put fuel there instead of bombs?
Not to my knowledge, there may have been propsals, how serious they were might be subject to question. it was used as a test bed for a number of engines.
What kind of engines was it a testbed for?
The fuel tanks were in the section of wing between the landing gear and the fuselage. The bomb aimer laid prone in the belly of the fuselage to use his bomb sight, ( a real clue the plane was not intended for low level bombing.)
Okay. Considering the goal of the bomber design was a light-bomber that could dive-bomb if need-be, I don't think that kind of change would be all that realistic to spec.
That said, a dive-bomber would have been smart: The RAF seemed to have little interest in it (very few proponents of dive-bombing remained), but it's fundamentally a good idea if you have a decent degree of speed and agility (SBD Dauntless).
as for the landing gear. . . . It retracted straight back and left 1/2 (or more?) of the wheel exposed. This helped make it a great trainer for an air force transitioning from fixed gear to retractable because in the event of a wheels up landing the plane was more easily repaired. However, for any talk of an "improved" battle for combat you have to change the landing gear to wind up flush, this is going to require more volume inside the wing. retracting inwards means the fuel tanks have to be moved or much reduced in size and new ones added elsewhere. retacting outwards puts them in the bomb cells. Perhaps you can retract rearwards and turn them like P-40 landing gear?
Rear retraction with a 90-degree twist seems workable. From what I recall, the P-36 had this kind of gear too...
The plane had a 106 imp gal tank in each wing root. perhaps for short range ground attack you could get away with smaller tanks.
IWould a P-36 style gear reduce fuel capacity? I figure more fuel is better (unless you crash on takeoff).
adding an extra gun (or 3) might not be that big a deal, you just have to provide access, run the firing controls and probably arrange for heating.
True, do you have any estimates how much the guns and ammo would weigh? As for access, firing controls, and heating -- do you have any idea how much that would weigh?
Please note that the Firefly MK 1 with a 1735hp Griffon engine and a wing about 75% the size and 9 1/2 ft less wing span was only good for 316mph at 14,000ft.
The Firefly's issues revolved around...
- A two-seat arrangement: It was based on the radio-navigation systems used being dependent on two crew instead of one crewmember: This would make the plane a little bit heavier and require a bigger wing to lift it along. That said, I'm not sure how much interval occurred between the following
- Fulmar being proposed or encouraged (official or not)
- Fulmar starting and finishing development
- Fulmar making first flight
- Fulmar entering service
- Firefly being proposed (official or not)
- Firefly undergoing development to first flight
- I know the Firefly flew 12/22/1941, and entered service in 3/1943.
- A thick wing over a thin-wing: Probably to improve carrier handling characteristics. I do think if there was a shot at getting up to 370 mph, I think that sounds pretty good, as it would probably solve a lot of problems seen in the Seafire...
The timetable is important to figure out what could be done.