Homebuilt Vacuum Forming Machine

Discussion in 'Questions on Kits, Decals, Tools and Pilots' started by hawkeye2an, May 7, 2010.

  1. hawkeye2an

    hawkeye2an Active Member

    Joined:
    Mar 18, 2009
    Messages:
    1,047
    Likes Received:
    1
    Trophy Points:
    36
    Occupation:
    Salesman
    Location:
    St Joseph, Missouri
    Here's my machine. Built for less than $70.
     

    Attached Files:

  2. Wurger

    Wurger Siggy Master
    Staff Member Administrator

    Joined:
    Jun 19, 2005
    Messages:
    47,610
    Likes Received:
    1,452
    Trophy Points:
    113
    Occupation:
    A retired military Navigator/ATC, FIS controller
    Location:
    Poland
  3. T Bolt

    T Bolt Well-Known Member

    Joined:
    Mar 24, 2010
    Messages:
    9,724
    Likes Received:
    194
    Trophy Points:
    63
    Gender:
    Male
    Occupation:
    Bridge & Highway Construction Inspector
    Location:
    Chicago, Illinois
    Wow!! That is slick! I'm tempted to make one.
     
  4. Airframes

    Airframes Benevolens Magister

    Joined:
    Aug 24, 2008
    Messages:
    47,652
    Likes Received:
    1,416
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    Retired
    Location:
    Cheshire, UK
    Good stuff! In my relatively small place, I'd need an integrated set-up though, as with the commercial vac-frames, which are similar to those used (if still used!) in the graphics-reproduction industry, but with an integral heat-source and vacuum pump.
     
Loading...
Similar Threads
  1. Colin1
    Replies:
    63
    Views:
    2,580
  2. sunny91
    Replies:
    0
    Views:
    949
  3. Colin1
    Replies:
    0
    Views:
    877
  4. Velius
    Replies:
    7
    Views:
    9,763

Share This Page