On the criticisms of the P-38
The P-38 performed usefully but suffered from a number of problems. Its Allison engines consistently threw rods, swallowed valves and fouled plugs, while their intercoolers often ruptured under sustained high boost and turbocharger regulators froze, sometimes causing catastrophic failures.
Number of rods thrown?
early turbo regulators froze, later ones were much better but not perfect.
Arrival of the newer P-38J to fill in behind the P-38H was supposed to help, but did not help enough. The J model's enlarged radiators were trouble-prone. Improperly blended British fuel exacerbated the problems: Anti-knock lead compounds literally seethed out and became separated in the Allison's induction system at extreme low temperatures. This could cause detonation and rapid engine failure, especially at the high power settings demanded for combat.
ALL P-38s used the same radiators. Later P-38s got bigger housings/ducts and moved the radiators a bit further out into the air stream. Also added boundary layer splitters.
The British fuel furphy has been addressed many times. Yes anti-knock compounds precipitated out of the fuel, they were heavy aromatic compounds, not lead compounds.
In an article on ausairpower.net, Carlo Kopp noted that in their early days in the European theater, "Many of the P-38s assigned to escort missions were forced to abort and return to base. Most of the aborts were related to engines coming apart in flight….[due to] intercoolers that chilled the fuel/air mixture too much. Radiators that lowered engine temps below normal operating minimums. Oil coolers that could congeal the oil to sludge. These problems could have been fixed at the squadron level. Yet, they were not."
The bolded part is large part of the problem. Fixing the problems at squadron level simply required the USAAF pilots to fly the P-38
as both Allison and Lockheed advised.
NOT as USAAF instructors or hanger know-it-alls advised.
P-38s in Europe (and other places) were routinely being flown at high rpm and low boost in cruise conditions in the mistaken belief that this would allow more rapid availability of military or combat power. This also resulted in less range as it used more fuel for the same power to the propellers.
A low rpm, higher boost, cruise setting with the turbos spinning faster would have meant higher intake mixture temperatures which would go a long way to solving many of the too cold engine problems. Increase the intake mixture temp by 100 degrees and the peak temperature inside the cylinder goes up 100 degrees and the temperature of the exhaust gas goes up 100 degrees as an example.
It also requires less fuel for the same power to props as you are not running at the higher rpm so you have less friction in the engine.
So a large part of fixing the engine problems doesn't even require a wrench or screw driver.
This would do nothing for the pilot being too cold, but it would do away with many of the engine complaints.
As far as getting bounced and having to go to full power goes, having the turbos spinning several thousand rpm faster to begin with may be more of an advantage the engine spinning faster but turbos idling.
Are we going to blame the aircraft for poor training and procedures?
British were using the low RPM/high boost method of cruise in 1942 with Spitfire MK Vs and other aircraft.