The Weather Where You Live? (5 Viewers)

A bit warmer than yesterday, around 11° C...

For me, it's freezing! I want summer back.
 
3 degrees and good visibility this morning
PXL_20261118_155920415.jpg
 
Got two inches of snow last night but ski resorts have delayed openings for the second straight year.
A ski resort in the province has maybe solved that problem... Sun Peaks gears up for early ski training season thanks to snow-saving technology | CBC News
 
Overcast, that's it.
YOU NEED sUNNYSIDE UP
 
Eggs, bacon and hash browns are good too! My children just hate hash browns!
Sunny side up (3ea) on top of crispy hash browns with thick cut bacon 🥓 and or sausage, biscuits, English muffins or pancakes

1795229155843.png


Say hi to miss don
 
Eggs, bacon and hash browns are good too! My children just hate hash browns!
This is is from my local Cafe (apologies for the terrible image - new phone, new learning curve. It was much lighter in there).
Ham & cheese omlette, crispy hash browns with a tough of garlic. Toasted and buttered english muffin with grape jelly.
20260730_104528.jpg
 
A little place called Black Bear 🐻 Dinner. Started out of Shasta California. Probably the only good to ever come from that state!!!!
Actually started in the town of Mount Shasta (Siskyiou county) which is north of me and we have one here in Redding (Shasta county).
 
It has been odd here. We had a 6 degree warmer Chinook wind blow in the other evening. It was 10 then in a few minutes it was 16, at dusk.
Tonight it was getting down to 2, then it was 6, at midnight. all over a couple of minutes. OK back to 2
The house uses OutDoor Reset (ODR) loop to set the service water temperature in the radiant floor heat. It is going a little bonkers with these fast swings.
Any chance that the software has a delay timer on temp resetting?
 
it has a ton of settings.
It has a Kp
Integral
Differential
Those are all part of the Proportional-Integral-Derivative (PID) Loop.
The controller repeatedly compares a target value (Setpoint, or SP) against a real-time sensor reading (Process Variable, or PV) to calculate the error (e = SP - PV). It then adjusts a Control Variable (such as valve position, heater power, or motor speed) using those three terms.
I may have exaggerated about it "going nuts" because I have it damped down to take the long view, with the integral at 800 seconds.
 

Users who are viewing this thread

Back