pinehilljoe
Staff Sergeant
Has anyone tried UV resin adhesive in their building? I was thinking for items like aerial antenna wire or biplane wire it might be a good option.
UV Adhesive use
- Thread starter pinehilljoe
- Start date
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
- Thread starter
- #2
pinehilljoe
Staff Sergeant
fubar57
General
I've never used it but I've heard good things about it. I use Uschi van der Rosten for my antennae. A tiny dab of CA on the post and the thread sticks immediately. I just bought some Infini Aero Black Rigging and I'm going to test drive it on the the Fw 190 I'm currently doing
Builder 2010
Staff Sergeant
If by UV adhesive you're thinking about a product like Bondic. I use Bondic extensively when reparing UV Resin 3D printed parts. When used as a filler with UV Resin, it essentially bonds completely with it since it's the same material. When using it on styrene, it's a bit different. I doesn't adhere very well and you best rough up the substrate a bit for more "tooth". What it can't do is cure where the UV light can't reach. This means any blind glue joint with have uncured UV resin in it. I have used it successfully to make lens cover for instrument panels and landing lights, (for example). It doesn't replace epoxy for strong joints, nor should it be used as a plastic glue unless it meets the critera I've noted. The fact that it stays uncured until you shine the UV light on it is great for positioning parts. When the light goes on, curing starts instantly and is solid in 5 seconds. If you're filling a deep space, apply it in layers and cure each.
