I believe your estimates for the accuracy of the bipod mounted mg and tripod mounted mg are way off. While not lazer beams and not as good as a rifle (and BTW WW II service rifles were only good for about 3-4 minutes of angle, 6-8 in groups with service ammunition at 200 yds) a "tuned" water cooled Browning could make a 10 shot group, all bullets touching on the 1000 inch (27.7 yds) range. In fact it had better be able to shoot that good if the Unit machine gunners were to earn their "expert" Badges.
First of all, the numbers I quoted for machine guns were not estimates. They are from what I recall from gun tests in various publications over the years. Perhaps my memory is faulty but I don't believe so.
From having fired many 20th century military rifles, 2.5-4 MOA sounds like typical accuracy from a rack grade M1 Garand firing service ammunition (we were shooting LC 67 and LC 68 ). A typical bolt-action does a bit better at around 2 MOA to 3 MOA with oddballs like the Swedish Mausers doing a LOT better. Some examples do better, some do worse, but this is typical of what I have encountered.
Ammunition for MGs for overhead fire during training comes from select lots which are much better quality than typical service ammunition (at least for the US military). I don't know if this is the same stuff used for qualifications.
Think about what you just claimed for your water cooled Browning: perhaps a 1 inch 10 shot group at 27 yards? Would that be around 4 MOA? I am curious as to how these guns were tuned. Perhaps all shots touching is a bigger group than that?
Also keep in mind that recoil operated guns are notoriously inaccurate which is why other than the Johnson rifle, pretty much no one uses this type of action in a semi-auto rifle. For MGs and pistols, it doesn't matter.
I mentioned the drop as a comparison between guns/ammo. I did say that you could point the guns up a bit ( and it only takes 1/3 of a degree or less to zero for 600yds. It is after these ranges that things can very weird, very quick. a weapon that has 0.2-0.3 seconds longer time of flight to 600 yds than another gun mounted on the same plane can be zeroed for the same impact at 600 yds/meters BUT it will not match at other ranges, and on a moving target it requires a different lead.
Agree with you on elevation: 42-44 MOA (0.75 degrees) from a 100 yard Zero to get to a 1000 yard Zero with a typical 168-175 grain boat tail spitzer at 2600-2650 fps. I have never fired AP rounds at targets, but a .30 cal AP bullet has about the same weight and MV though it isn't a Boat Tail.
Disagree with you on what the result is. Keep in mind we are discussing what an expert air to air marksman can do. Making a high deflection snap shot in a twisting dogfight changes everything.
My long range .308 using a pretty streamline bullet and a MV of 2950fps ( do not use this load in a semi auto) drops 5 feet between 900 and 1000 yds. and one mph of cross wind is worth "about" 1 minute of angle on the sights (14 mph cross wind needs 14 minutes or 140 inch correction) If I remember right. And 'windage' is another example of long range gunner problems, doubling the range usually increases the wind drift about 3 1/2 times for the same value wind, due to the longer flight times.
.
Sounds like you have a Palma rifle. They aren't really representative of service guns. Keep in mind that because the .308 cartridge is mandated for competition, folks are playing all kinds of tricks to juice up the MV to keep a HPBT Match bullet above the trans sonic range out to 1000 yards. Your objective is target accuracy. We are discussing aeroplane hitting accuracy and the reason I picked 750 yards is because I believe rifle caliber bullets aren't that different from a medium velocity cannon out that far. My typical .308 load of 168 grain HPBT at 2640 fps is closer to what a rifle caliber AP round would be doing in my opinion. I push these same bullets out to a bit past 3000 fps in other guns, but that also isn't terribly relevant to a rifle caliber MG.
Your 14 MOA correction is interesting but a bit simplistic. The correction isn't a constant MOA. The MOA increases as range increases. In any case, the REAL question is how different a rifle caliber round flies as compared to a 20 mm cannon round, and I do not believe there is a great difference.
A few inches here or there is not of much concern. and at close ranges are nothing to worry about. At long ranges (500-600yds/meters and more) ALL the errors keep piling up making successful long range aircraft fire increasingly iffy. Other pilots may do better but some British pilots in "tests" misjudged the range by up to a factor of 3. That is opening fire at 3 times the range they had been instructed to do so.
I contend that a few inches is not all that important when your target is the size of an aircraft and your dispersion is typical of a machine gun. I figure even 10 feet isn't all that important. Regarding your "some British pilots", these guys were obviously NOT the expert marksmen we were discussing.
I believe the discussion was about whether there was an advantage for centerline armament for an expert marksman which presumes he knows how to judge distance and proper lead.
Regards.
- Ivan.