Crimea_River
Marshal
Good stuff. I run a scalpel along the panel lines of unsettled decals then reapply the setting solution.
Bf 109G batch build 1/72, FM x3 Tam x1
- Thread starter Ruud
- Start date
A4K
Brigadier General
Good idea Andy! I will try that myself if need be.
Nicely done so far!
- Thread starter
- #84
Vic Balshaw
Major General
Nice looking machines. 
- Thread starter
- #86
Vic Balshaw
Major General
Each time you show them they look better and better.
Last edited:
Crimea_River
Marshal
With Vic.
A4K
Brigadier General
Agree with Vic! All looking great mate.
- Thread starter
- #91
Looks good so far!
- Thread starter
- #93
Vic Balshaw
Major General
Not an easy task and I would have thought an impossibility in this scale.........................Very brave of you!
- Thread starter
- #95
i never thought i would be capable, i figured i'd just ruin the part. But having (somehow) successfully drilled out the 7.9s of the G-4 and the 20 mm and 7.9s on my E-4 in the past… i knew i had to try.
i start with a needle in a pin vise to get a little divot in the center, then enlarge it with my smallest drill bit, then turn a sharp and pointy blade to open it up.
not master class results, but i'm pleased.
forgot to add: i check to see if the needle is centered by turning the barrel on the needle. sometimes it looks centered, until i turn it 90 degrees…
i start with a needle in a pin vise to get a little divot in the center, then enlarge it with my smallest drill bit, then turn a sharp and pointy blade to open it up.
not master class results, but i'm pleased.
forgot to add: i check to see if the needle is centered by turning the barrel on the needle. sometimes it looks centered, until i turn it 90 degrees…
Last edited:
A4K
Brigadier General
Great job mate.
fubar57
General
Awesome job drilling out the guns
Good work so far!
- Thread starter
- #100
