I was updating my sig to include this latest build and went back into history to see how many times this has been done; SIX!! I also realized that I technically allowed Maritime and Carrier. There's a difference. Ooops. I promise to look over the categories 7 times on the next cycle.
I always repeat ... don't paint part areas for gluing before assembling. A paint is a very good protection against a glue. A such joint is always weak and crack very often. Secondly I guess you was attaching the wings while the fuselage was on the pole, wasn't you?
Actually the correction is not as difficult as expected. A some of working has to be done but may be worth. The main problem is that th bottom wings were glued with the incorrect dihedral judging by the images you uploaded. IMHO it can be corrected in quite easy way. Firstly the joints between the landing gear struts have to be split up. It can be done with a razor blade. Secondly , the joint at the wing roots have to be cut across the front and back of the roots in order to separate the wings from the fuselage. If needed the area at the fixture key ( blue line in the shot ) also should be notched. A razor blade again. It should help to separate the parts easier. Having that done , the bottom wings have to be re-glued again with the correct dihedral. Because all angles get changed so I would cut off all the struts, pehaps leaving these short ones between the fulealge sides and the wings. I noticed these seem to be in the air and not to be stuck to the top surface of the bottom wings. But it is possible that it could be enough to bend a little bit the main landing struts at the fuselage fixing points only to get them set correctly with the supporting struts from the undersides of the bottom wings. These struts also seem to be not necessarily to be cut off and may be also bent a little bit if needed. And then join all them again at the wheel shaft. But the choice is your.
I got this result with mine, though I did have to sand the tops of the interplane struts down a bit ('til the lower edge of the bar was flush with the lower surface of the upper wing.)