**** DONE: GB-48 1/48 SB2U-3 - Carrier & Maritime Patrol A/C of WWII (1 Viewer)

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

I have a new airbrush compressor coming by Sunday, so they say! Hopefully I can finish up then.

Paasche Airbrush D3000R 1/5 HP Compressor with Tank, Regulator and Moisture Trap
$138 off Amazon
71nzMrEGUTL._AC_SL1500_ (1).jpg
 
OK so I have a dilemma! AM instructions call for wing insignias top and bottom both port and starboard, rather than port top and starboard bottom. I though by Midway it was the later, What say ye all?
 
OK love the new compressor tied to the Talon I'm loven' it.

I wasn't sure about the insignias till I did some searching and decided AM knew their stuff.

I painted the walkways on and then tried to remove then via scuffing!:p

20210228_114741.jpg

20210228_114748.jpg

I started by putting the insignias on as I thought they should be.
20210228_120315.jpg

Did some research and concluded yep, don't worry I fixed that meatball! Note the tail decal. AM did a nice job on that as a light spray over the tail.
20210228_145711.jpg
20210228_145739.jpg

Next I'll need to put the white over the meatballs, and the same for the fuselage insignias.
 
OK so I got the insignias done. Need to mask off the white strip just behind the gunners compartment and shot that. Not sure the full concept of the red bleed through is noted but....

20210301_163923.jpg
20210301_163930.jpg
20210301_163934.jpg
20210301_164009.jpg
 
OK dokay, well had to paint the white stripe.
I used some Testors 3mm tape to mark the mark the stripe then added the Tamiya masking tape to the back side.
20210302_101231.jpg

All masking was run a couple times on my had to reduce tack. Using Tamiya vinyl tape for the forward mask due to the more complex curves.
20210302_101302.jpg
20210302_101421.jpg
20210302_101428.jpg

Choosing my Talon for the task at hand.
20210302_101434.jpg
20210302_101523.jpg
20210302_101531.jpg

As usual Vallejo Model Air.
20210302_101546.jpg

Set the compressor with three drops of white in the cup.
20210302_101700.jpg
20210302_101848.jpg

And remove the mask! I know you pros taught me all these trick so just to let you know, sometimes I listen:rolleyes:
20210302_102413.jpg
20210302_102430.jpg
 

Users who are viewing this thread

Back