fubar57
General
Nice
**** DONE: GB-60 1/32 Bf110 C-7 - Zombie Build
- Thread starter Donivanp
- Start date
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
Vic Balshaw
Major General
All good stuff.
- Thread starter
- #64
Donivanp
Major
Nice work so far!
Like the look of that...!
- Thread starter
- #67
Donivanp
Major
Moving right along. Built up the upper gun bay and the nose. Attached the lower wing spars and low fuselage.
fubar57
General
Nice
Vic Balshaw
Major General
Coming along nicely Don. 
Crimea_River
Marshal
Very sharp.
Good work so far!
Good stuff.
- Thread starter
- #74
Donivanp
Major
Well I'm working in the main gear well. In what universe does this make sense?
I finally had to go about it by dry fitting things where they were supposed to be. The main gear on a 110 is kind of goofy in my opinion any way. So here I got the main gear fitting in place.
I don't want to mount the gear until the end. I can get away with just installing the mounting points.
So working on the radiators I ran into another "OH gee I'm an engineer and I can really screw them up here for fun" drawings. But I was piecing it all together when the carpet monster got hungry.
I finally had to go about it by dry fitting things where they were supposed to be. The main gear on a 110 is kind of goofy in my opinion any way. So here I got the main gear fitting in place.
I don't want to mount the gear until the end. I can get away with just installing the mounting points.
So working on the radiators I ran into another "OH gee I'm an engineer and I can really screw them up here for fun" drawings. But I was piecing it all together when the carpet monster got hungry.
Last edited by a moderator:
Vic Balshaw
Major General
Mmmmmmmmmmmm..................................even viewing it from down under and inverting the vertical instructions to the horizontal.................................NOPE, makes no sense. Looks like your on the right track though. As for the carpet monster, I've heard that a bit of stocking over the vacuum nozzle may help find your part. Anyway, good luck in finding it.
Crimea_River
Marshal
These are pics I downloaded off the net many years ago. I tried a reverse search but could not locate a source.
- Thread starter
- #78
Donivanp
Major
Thanks Andy. I did get it figured out but had to take each part and slow and methodically dry fitting. I did not want to install the legs until the last step but did need to install the support struts. I had been looking for these type photos though.
Good work so far!
- Thread starter
- #80
Donivanp
Major
I really don't know why it has to be this difficult.
This makes it look like I'm supposed to glue the face of the radiators together and then into the housing. When in reality the two halfs glue back to back and I found it smarter ti glue them into their wing mount and then the housing on.
Here one wing is fitted on.
This makes it look like I'm supposed to glue the face of the radiators together and then into the housing. When in reality the two halfs glue back to back and I found it smarter ti glue them into their wing mount and then the housing on.
Here one wing is fitted on.
