**** DONE: GB-68 1/48 Fw-190A-8 - We all build Fw 190 (1 Viewer)

Any time Andy. I actually stole the idea from Brett Green. He uses it all the time. This is what he wrote and I do as he says

1770095053100.png
 
Lovely work so far Andy!
 
Thanks all.

Some fiddley bits added today. Pitot tube and cannons from brass tube:

26020401.jpg
26020404.jpg


After enhancing the exhaust stains, I glued on the dirtied up drop tank, managing to match the holes I mentioned in the last post. For the Morane antenna, I used the kit plastic rather than the flat PE piece. The short whip portion is stretched sprue.

26020402.jpg


D/F Loop and IFF spike also added. The loop is PE form the kit and the later is stretched sprue.

26020403.jpg


All this obviously needs paint to finish it off. Thanks again for stopping by.
 
Gun barrels are a nice improvement. I don't have a place to buy those so I'm stuck using stretched empty Bic ink cartridges
Got mine direct from Albion Alloys years ago. Not sure they sell direct anymore but Sunward Hobbies does.

 
Thanks Andy but Sunward doesn't ship to my postal code
 
I will need to cut back the MK108s as the barrels seem a bit long. I matched the kit parts for these but they would have probably gone further into the wing.

View attachment 866421

Andy, not MK108 but the MG151. The A-8 variant basicly was armed with the MG 131 at the fuselage compartment and the MG 151 both as the inner and outer armament at the wings. The MG 151 had the quite long barrel protruding the wing leading edge. The A-8/R2 and R8 sub-versions had the MK 108 cannon as the outer armament in wings. The cannon had a short barrel protruding from the wing leading edge just a little bit. In all pics with the MG 151 installed it can be noticed that the barrel of the outer MG protruded slightly forward than the one of the inner gun or these were at the same line at least.

MG151
A8.jpg

a8r11.jpg


a6'.jpg

a6_.jpg

a6_a.jpg


MK108
A-8_R8.jpg

a8r2.jpg
 
I thought I posted the next pic yesterday but I forgot to hit the button. Anyway, I fixed the cannon barrels with the outer ones shortened and inner ones made longer:

26020501.jpg


Today, I added the MG131 barrels (right Wojtek? :lol:) which were cut from the full gun molds, inserted into the cowl with a blob of CA on the ends, and then painted.

26020602.jpg


I had sprayed the exhaust stains the other day and today I added some chipped paint on the air louvres and oil streaks based on photos on page 1. There's also a small amount of chipping done with a silver art pencil.

26020601.jpg


Finally, the antenna wires were added using invisible mending thread. The wire leading into the fuselage was tricky and I just couldn't get it very tight so I left it alone after the third try.

26020603.jpg


I could kick myself for putting the swastikas too low on the fin but every model I do has a wart or two so this one will be no different.

I'll post some finished pics at the end of this thread on Sunday but won't enter this into the judging. I removed myself from the judging panel last year and don't consider it fair for me to turn around and ask the judges that stayed on to spend the time rating this entry so I'll leave it at that. Thanks again for looking and for the comments and likes.
 
Very nice, Andy
 
:thumbright:
 

Users who are viewing this thread

Back