Junkers Ju 88 G-6 conversion

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

piet

Senior Airman
438
2
Aug 27, 2009
Home

an exciting new conversion set for the Revell 1/32 Ju 88. The set will enable you to make one of the various Ju 88 G-6 configurations.

Vacuformed Brass Resin Scratch building required
Fighter canopy with armoured windscreen
Mid-spine section for clear EZ-6 cover
Belly from nose to end of gun bay
Morgenstern cap

SN2 220 dipoles x5 (4x for front and 1x for rear)

Vertical stabilizer
Rudder
Extensions to horizontal stabilizers and elevators
Wing tips
Revised ailerons with proud trim tabs
Jumo 213 engines with spinners, VS 11 props and flame dampers
Under wing vents
Extended forward cowls
Standard nose
Berlin (long)
Morgenstern (covered plywood area)
MG 131 rear defence
MG 131 ammo bin
Fabric effect cartridge chute
Covered ammo belt feed
SN2 antlers
DF loop base
Upward firing cannon fabric boot
EZ-6 housing

Some panel lines will need scribed
Gear doors will need revised

Boxes to back of interior radar equipment will need fabricated for photo-
 

Attachments

  • g6.jpg
    g6.jpg
    53.5 KB · Views: 248
  • g7.jpg
    g7.jpg
    54 KB · Views: 252
the two A/C in camo from NJG 5 AA and AAC both have the SM installation of two 2cm cannons side by side, I have told John this days ago but .............photo proof.

hopeful you guys will grab one of these sets it looks like the bet thing yet made. also the NJG 4 with the red front prop hubs is incorrect, not sure of the colour but do not think it is red.
 

Users who are viewing this thread

Back