MikeHoulder
Airman
- 15
- Jul 24, 2009
Hi folks, I've been around a bit in the forum, but not in this section. It may be a very good place to get some criticism.
These pics are from my 3D CAD drawings at full scale derived from a clutch of badly corrupted photocopies of the original Avro drawings. I've tried to preserve the nominal Avro precision of 0.4 mm (1/64 inch). But there's still a lot of deduction and interpretation on my part.
Sorry the pics are big; but they have to be to see the detail.
This last pic is a test piece to determine the supports for the turret deck. The outer diameter of the turret ring as shown above is a tad less than 44 inches. There seems to be the possibility that this is too big. I derived this by eye from a good photo and a very badly corrupted Avro drawing. So I'd welcome suggestions.
And I'd welcome very greatly detailed drawings or photos of any part of the Lanc fuselage.
Mike
These pics are from my 3D CAD drawings at full scale derived from a clutch of badly corrupted photocopies of the original Avro drawings. I've tried to preserve the nominal Avro precision of 0.4 mm (1/64 inch). But there's still a lot of deduction and interpretation on my part.
Sorry the pics are big; but they have to be to see the detail.
This last pic is a test piece to determine the supports for the turret deck. The outer diameter of the turret ring as shown above is a tad less than 44 inches. There seems to be the possibility that this is too big. I derived this by eye from a good photo and a very badly corrupted Avro drawing. So I'd welcome suggestions.
And I'd welcome very greatly detailed drawings or photos of any part of the Lanc fuselage.
Mike
