- Thread starter
- #101
fubar57
General
Thanks guys. Not sure what the pipes are for or where they come from Herman but you seem to be correct as to where they go...
.....other side glued up, again a nice tight fit...
.....tight is the word here. I started from the back and forced the wings into the fuselage, running Tamiya Extra Thin about an inch at a time and holding the area together for about 20 seconds before moving along. Its not really needed, I used the clamp just to make sure. I did an test fit of the upper cowl piece and once again the join is a very tight fit and seamless along the rear and sides, a minor gap about a half inch along on the front
Last edited: