For the frames I used clear decal film painted. First painted RLM02 and then RLM71.
I cut 1mm stripes to approximate length of the section. apply as per usual decal methods.
After completing, use Micro Sol to make it conform to the part.
Cut decal stripes of about 1mm and to desired length
Here you van see the inside colour showing through on the middle frame
It is a little bit of a work perhaps, but heaps better than to cut out masks for those complicated canopy frames. The final result is, by far, better than masking.
I'm now reaching the final steps of this building. Most probably the next photos will show the completed model.
The idea of the decal strips is good. However there is a possibility of unsticking in time, especially at edges.. Unless you would varnish the entire cockpit canopy with a gloss clear coat..