**** DONE: GB-42 1/32 Bf109F-4/Trop - MTO II

[Gnomey]

Great work so far Wayne!

 

[Crimea_River]

Looking very good.

 

[Wayne Little]

Thanks Guys,

Props and spinner Assembled and some paint "removed" from the rear of the blades.

First Flat coat applied to the aircraft.

 

[Wurger]

 

[Wayne Little]

Cheers Wojtek.

 

[Crimea_River]

Great! The back of those props are often ignored. Well done Wayne.

 

[Airframes]

I agree.

 

[Gnomey]

Looks great so far Wayne!

 

[destrozas]

beauty mersser!!! wayne

 

[Wayne Little]

Thanks Guys, second Flat coat applied to dull it right down and a diluted misted spray of XF-60 oversprayed to give it a slightly dusty look....

So just the the final bits'n'pieces to paint and attach to get her finished this week....

 

[Wurger]

 

[rochie]

Nice

 

[Gnomey]

Great work so far Wayne!

 

[Crimea_River]

Looks great Wayne. I did the same to dull down my Storch though I used a different colour mix. I think it works a treat.

 

[Wayne Little]

Thanks Guys!

added the Pitot tube, wing lights and mass balance on the ailerons today nearly done.

 

[fubar57]

Beauty Wayne. I may try that on my finished Spitfire in the near future

 

[Wayne Little]

Thanks Guys.

had a minor setback....spilled a drop of tamiya extra thin on the wing root when doing the undercarriage, quickly prevented it from doing major damage.....was not a happy chappy...the spill did not spread too far and I hoped spraying another flat coat would fix it......turned out to be right as it hadn't eaten into the paint and plastic...dodged a bullet on that one....
Will be done tomorrow....

 

[Crimea_River]

Got lucky there. I had that happen on my P-40 Cleopatra III but with thin CA. Had to sand it down and repaint.

 

[Wurger]

 

[fubar57]

Good save. Usually my thumb print is embedded into the plastic after a glue spill