**** DONE: GB-45 1:48 Slovakian Bf 109G-6 - BoB/Foreign Service

fubar57 · Apr 12, 2020

Minor setback on getting the air-frame painted. Eduard chose to have everything open: flaps, radiator doors and leading edge slats. Going to have to paint some areas RLM02 and then work out a masking routine

Crimea_River · Apr 13, 2020

More work.

destrozas · Apr 13, 2020

good job geo!!!

fubar57 · Apr 13, 2020

Thanks Sergio. This is has Eduard would have one mount the flaps. Though I have found two photos in five books showing the flaps lowered like this, most are not as aggressive or lowered at all.

A lot of material would need to be remove to set the flaps flush so I've settled on a halfway position that seems to be more standard. I clipped off the locating lugs and got a very decent fit. One side done and when the glue sets, I'll do t'other

fubar57 · Apr 13, 2020

Flaps is done. Waiting to set up and then start masking the cockpit and wheel wells.

Wayne Little · Apr 14, 2020

Nice man....

Wurger · Apr 14, 2020

fubar57 · Apr 14, 2020

Merci. Prepping for the yellow fuselage band and wing tips with Vallejo primer. As is my wont, it sets for 24hrs.

While waiting I added brake lines to the landing gear and put together the three part tail gear. A very finicky affair. The smallest yoke part is extremely hard to pick up, never mind put it it place. I slid the wheel onto the axel, added some glue to the 1x1.5mm attachment point and dropped the smallest part as near I could. Took a few minutes to line up. A few touch-ups required.

Wurger · Apr 14, 2020

Crimea_River · Apr 14, 2020

Good job on the gear.

fubar57 · Apr 15, 2020

Thank you . Yeller has been spritzed, VMA 71.078 Gold Yellow

Crimea_River · Apr 15, 2020

Always a butt puckering moment with yellow. At this point I usually find out that I didn't apply the yellow wide enough to pick up the edges of the band.

Wurger · Apr 15, 2020

fubar57 · Apr 17, 2020

Sprayed on the RLM76 using VMA 71.046 Pale Grey Blue. I used a many settings and exposures to get the correct looking color but it was either too grey or blue. In real time its a shade greyer than the photo but still maintaining the bluish tinge

I removed the wingtip masks immediately and no paint lift. I'm hoping the fuselage band will behave as it has to stay on for a day or so more

Wurger · Apr 17, 2020

Airframes · Apr 17, 2020

Looking good Geo. The exposure / colour balance problem is probably caused by the blue background, partly 'fooling' the camera sensor.

Crimea_River · Apr 17, 2020

With Terry.

fubar57 · Apr 17, 2020

Thanks guys. I've also got a greyish sheet that I haven't cut up to fit in the booth

fubar57 · Apr 17, 2020

Here is a test with three different backgrounds. On the left is the camera set in "Auto Mode" and on the right is "Program Mode". Grey background in Auto seems to be the closest

fubar57 · Apr 17, 2020

While I'm waiting for the bottom camo to harden I'm trying to figure out how the upper camo encroaches on the wing root. This is Eduard's rendition

If I follow that does it follow the panel up the fuselage?

I've found about a half dozen different upper camo schemes for the G-6 and none seem to be a perfect match for the Eduard scheme. This one seems the closest but doesn't have RLM74 at the wing roots.

HTMODEL SPECIAL - SUMICHRAST/HOCHMUTH/AND`AL

**** DONE: GB-45 1:48 Slovakian Bf 109G-6 - BoB/Foreign Service

General

Marshal

Senior Master Sergeant

General

General

Moderator

Siggy Master

General

Siggy Master

Marshal

General

Marshal

Siggy Master

General

Siggy Master

Benevolens Magister

Marshal

General

General

General

Users who are viewing this thread

Similar threads