Crimea_River
Marshal
Not pleasant but nothing you can't handle Glenn. The end result could be worth the work though.
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
Thanks, I didn't notice that. I made the first one up for 36599, the one with the counter rotating prop because that's the one I plan on doing at this point. I then copy and pasted it and changed the last 9 to an 8 without looking at it close enough, just in case I had to switch for some reason. Nothing is printed yet so it's an easy fix.Nice. But a note though .. the digits "7' and "2" of the "XP72" for the 36598 have the small bar connectors while the 36599 didn't. The enlarged shot shows it better. So you need two variants of the "XP72" markings depending on which one are you going to make.
I've been working on it and have it mostly done with thick CA, just a small hole left here and there.Oh Glenn, had that resin Swiss cheese effect on a build many years back and was wondering when you started this build if you would come across the same problem. The filler solution worked on the deeper holes but I had to use thick CA glue to fill the shallow ones with a lot of sanding. The decal template looks great. A bit of a tip if I may, I've found the decal prints to be quite thin the colour not so deep so made duplicates and applied both to the model, one on top of the other which gave greater depth to the colour.
Thanks, I didn't notice that. I made the first one up for 36599, the one with the counter rotating prop because that's the one I plan on doing at this point. I then copy and pasted it and changed the last 9 to an 8 without looking at it close enough, just in case I had to switch for some reason. Nothing is printed yet so it's an easy fix.
Edit: Now that I look it closer, I see that the 2 is a completely different shape and the 8 has horizontal bar connectors as well as the vertical ones I put in. No problem, just a bit more to do.