**** DONE: GB-60 1/32 Bf109G-2 / G-4 - Zombie Build (1)(2)

Vic Balshaw · Nov 20, 2023

The master at work. Brilliant stuff Wayne. :thumbright:

fubar57 · Nov 20, 2023

Very nice Wayne. Just used stretched sprue to fill in some gaps on my Oscar; far neater than mud

Crimea_River · Nov 20, 2023

Nice. Drilling out exhausts is not one of my favourite pass-times.

fubar57 · Nov 20, 2023

Mine either....just did it

T Bolt · Nov 21, 2023

Great wrok as usual Wayne

Wayne Little · Nov 22, 2023

Thanks Guys.

First 2 pics show the nose gap from the panel inserts which was again filled with stretched sprue, you can see the fill in the last 2 pics from the previous post #39
The panel line sits less than a millimeter behind it.
Pic 3 shows the undercarriage box sections in place. In the instructions A80 and A82 numbers need to be switched with each other, the same goes for the other side too A88 and A90.
Pics 4 & 5 starboard lower and upper wing sections are fitted along with the leading edge slats, flaps and Ailerons too.

Vic Balshaw · Nov 22, 2023

Looking good Wayne. :thumbright:

Wurger · Nov 22, 2023

Crimea_River · Nov 22, 2023

It's a bit unnerving when there are typos in the instructions. Caught a few myself.

Ralph Haus · Nov 22, 2023

So nice and so much detail. 1:32 and some (your) skilled hands are a match.

Gnomey · Nov 23, 2023

Great work so far Wayne!

Wayne Little · Nov 25, 2023

Thanks guys, some busy times but still moving along... the Port wing added...with its bits...

Vic Balshaw · Nov 25, 2023

Your usual fine clean work Wayne. :thumbright:

Wurger · Nov 25, 2023

Gnomey · Nov 25, 2023

Looks great so far Wayne!

Crimea_River · Nov 25, 2023

Not your standard upper and lower wing half.

Wayne Little · Nov 27, 2023

Crimea_River said:
Not your standard upper and lower wing half.

No, not what I am used to, but being careful it did go together pretty well.... the upper joint was filled with some stretched sprue, sanded and rescribed......easy peasy....actually.

Wayne Little · Nov 29, 2023

Thanks Guys. On to some tail work with the Horizontal stabs and elevators..... the raised detail is a little overstated so removed the little discs from the visible upper surfaces. The Elevator halves have separate sections of the small trim tabs, once joined they leave a small gap which I have filled with some kit sprue.
this was then trimmed and carefully sanded to clean them up.....a tad more and will be sorted.
The tail wheel panel has also been carefully fitted too in the last pic.