Great work so far Wayne!
**** DONE: GB-60 1/32 Bf109G-2 / G-4 - Zombie Build (1)(2)
- Thread starter Wayne Little
- Start date
Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
- Thread starter
- #82
Thanks Guys.
be aware for those that may build this kit, the BLUE marked parts/sections are incorrectly marked in the instructions and reversed.
The RED marked radiator parts should be sanded down a tad to ensure they fit well with the lower wing sections as the Small ramps pieces that fit the lower wing in next pics sits against the base of the radiators. you can also sand back a bit of the edge of this as it really won't be seen and you will get a better, good fit of wing sections when you close them up.
next Pics show the filling of the small panel (for later mark Antenna) with thin piece of plasticard in the bottom to raise the rectangular part just slightly, I then glued some thin stretched sprue around it. Once dry, sanded flush and you can barely see where it was...!
be aware for those that may build this kit, the BLUE marked parts/sections are incorrectly marked in the instructions and reversed.
The RED marked radiator parts should be sanded down a tad to ensure they fit well with the lower wing sections as the Small ramps pieces that fit the lower wing in next pics sits against the base of the radiators. you can also sand back a bit of the edge of this as it really won't be seen and you will get a better, good fit of wing sections when you close them up.
next Pics show the filling of the small panel (for later mark Antenna) with thin piece of plasticard in the bottom to raise the rectangular part just slightly, I then glued some thin stretched sprue around it. Once dry, sanded flush and you can barely see where it was...!
Vic Balshaw
Major General
You've a good eye for detail. 
Snautzer01
Honourably banned
- 39,510
- Mar 26, 2007
What above says.You've a good eye for detail.
- Thread starter
- #86
Thanks Guys....motoring along...the wing sections are in place Horizontal Stabs in place too, flaps and slats prepped to go on too.
both Rudders assembled and the raised Rib stitching coming of so as not to interfere with the rudder markings...
both Rudders assembled and the raised Rib stitching coming of so as not to interfere with the rudder markings...
le_steph40
Chief Master Sergeant
Crimea_River
Marshal
A lot of fiddley work but it will look great in the end.
great work as usual Wayne
fubar57
General
Agreed
Looks great so far Wayne!
- Thread starter
- #93
Thanks Guys, I have moved forward pretty quickly in past few days attaching the necessary bits and filling and sanding to the point where I have now squirted the Yellow ID markings on both birds... first 3 the G-2 the others the G-4.
le_steph40
Chief Master Sergeant
Vic Balshaw
Major General
You've got that lovely deep yellow again.
fubar57
General
Not sure what happened here....
Last edited:
fubar57
General
- Thread starter
- #99
Thanks Guys, some G-2 Masking of Id markings and canopy.
Vic Balshaw
Major General
Now a nice big area to spray, hope you have plenty of paint.
