Test shot of Tamiya primer over all the worked areas. The gun cowl fit is not perfect, but it wasn't on the real machine either so it will stay as is. The Mosquito got the same treatment to test the seams.
This underside shot shows that I elected to go with a bare metal wheel bay, except for the engine baycovers which are RLM 02. One rib has fallen out but I have it and it will go back in. The port aileron was also test shot where I had to add a thin bit of styrene filler to make up the gap created by the mismatched wing halves on this side.
This coming week or two should see a push to get this project done as I'll be tearing up and rearranging my workshop along with my modelling bench after that. Thanks for your continued interest and for the comments.
So I'm looking at the wheel wells again and it suddenly hit me that something was amiss. I know from having taken detailed photos of FHCAM's Fw190 that the ammo containers should protrude into the wheel wells, like so:
Here's what my model looked like:
Once again the instructions threw me for a loop and I somehow managed to glue the ammo boxes too high up the firewall, despite there being locating blocks. This is the reason I couldn't get the gun cowl to sit down as the ammo chutes, being too high, were in the way. This is disappointing as I consider myself an experienced, careful modeler and yet this happened. That said, it was a simple fix to make the boxes look correct and I did so by building them up with square rod and card:
I'm now getting close to a final seam check and then will start laying down some paint and I might be able to get some done tomorrow. See you later.
I just checked mine. As I have the cowl still open, I can see that there's no way the boxes would have protruded into the wells even though mine was a bit cockeyed.
Motivation and available time combined for a short session at the bench last night. I've always been intrigued by subtle preshade techniques as I like to strive for some form of realistic weathered surfaces rather than presenting my models with the monochromatic colours that would be more representative of factory fresh subject or pampered modern day restorations. To that end, I purchased an AK mottling stencil some weeks ago and thought I'd give this a try.
Here is the preshaded underside using Tamiya black and white paints shot through the tightest patterns of the stencil:
The first very thin coat of AK RLM 76 was then shot on.
This is going OK but a) it will need a bit more blending with more coats as the pattern is still too visible to my eye and b) to me, the pattern is still a bit too coarse and would probably work better on 1/32 kits or larger. I will continue working this and will report back when the next steps happen.
As an Amazon Associate we earn from qualifying purchases.