GB-65 1/48 YF-4E Phantom - No Propellers (1 Viewer)

Nice work so far!
 
What I go thru for decals. I may paint the blue, just get thin stripes for the o'lines.
I found images of 1/72 stripes but when traced, enlarged I found they were to wide!!!
So back to tape, pencil rubbing and tracing my own!!!!!!
GB65-3.jpg
 
Good stuff Cap'n Bill.
 
I don't have access to your custom decal maker so would mask and paint the whole thing. Spray rough black strip first. Cut thin strips of masking tape and apply where the black outlines go, then spray white all around the masked black strips, mask the outer white areas, paint the blue, then strip. And Bill's your uncle.
 
I don't have access to your custom decal maker so would mask and paint the whole thing. Spray rough black strip first. Cut thin strips of masking tape and apply where the black outlines go, then spray white all around the masked black strips, mask the outer white areas, paint the blue, then strip. And Bill's your uncle.
You have access thru me for Custom.
 
As my friend Xavi says, "it's time to start making tapes" as Andy says, except that I would mask the black area and then cover it with white, it would be more difficult.
 
Are you able to do small writing in 1:72 Bill?
Give me a sample!!!!!! All scales, printer is ignorant of size!
 
So dealing with the "stripe" and the silly contour....... gadzooks.
Took some cogitating but came up with a solution.
As you can see from the above post, taped what I wanted.
GB65-3.jpg
Then I made a "rubbing" of the tape as the decal is limited in bending!!
The rubbing is done with the side of a pencil lead.
GB65-4.jpg
I then scanned it, then traced it in Corel and printed it.
GB65-6.jpg
I cut the Tracing out of the print and BAM, fits! Works!!!!
Ready to print, just have to decide on colors.
And...................... start building!
GB65-7.jpg
 

Attachments

  • GB65-5.jpg
    GB65-5.jpg
    65.8 KB · Views: 67
You're a magician Bill
 
Where there is a will,
There IS a way.
Decals for non-flat surfaces are not easy.
Decals are not very Bendy!
 

Users who are viewing this thread

Back