What's on The Workbench (4 Viewers)

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

Spritzing done....for the most part. A couple rookie mistakes. Anyone that's used Oramask film knows that it isn't very bendy so I use little bits of hold down tape until I'm ready to spray. When I'm ready to spray, I'll remove the lil bits of tape, press the Oramask down and spray. A few touch-ups, not big deal. The roundel will cover up the lack of Dk. Green on the left wing. I was getting really bored with masking by this point. I let this set and then do the yellow leading edge stripes in a day or so; backwards, yes but easier for me to mask this way

IMG_3342.JPG


IMG_3343.JPG
 
Last edited:
Thanks all. Leading edges have been spritz with my yellowy/slightly red mix. A few months ago I pre-mixed full Tamiya 10ml bottle full of this. Should save mixing for a while

IMG_3345.JPG

I also shot the prop tips with this and after the Canucks disappoint me once again, I'll fix my Dk. Green boo boos
 
Deecals have started. As per Andy's build, I started with the wing-tip walkway line to ensure everything else lined up. What attracted me to this aircraft is the caption said it had late war roundels on the upper wings....so be it

IMG_3346.JPG

Not sure what Airfix's thoughts were but for some reason they neglected to mark out wing tips lights so I used one of my Mk.Vs for measurements and painted them on
 

Users who are viewing this thread

Back