Arma hobby PZL P.7A in 1/72

fastmongrel · Mar 31, 2021

I love the look of these little Polish beauties clean lines and a menacing aspect.

Typical Arma sprue nice clean moulding and minimal flash

Wurger · Mar 31, 2021

Nice. Looking forward to the assembling.

A couple of pics of the "White 999" you may find in the Media section ...

Search results for query: PZL P-7a

Crimea_River · Mar 31, 2021

This should go together better than some of the more challenging kits you've been trying.

fastmongrel · Mar 31, 2021

Crimea_River said:
This should go together better than some of the more challenging kits you've been trying.

It's one of the reasons I have gone for this kit. I know Arma kits go together with very little wrestling and it's only 39 parts. I hope I don't have to use a single clamp

fastmongrel · Mar 31, 2021

Wurger said:
Nice. Looking forward to the assembling.

A couple of pics of the "White 999" you may find in the Media section ...

Search results for query: PZL P-7a

Thanks I have downloaded those pics.

Wurger · Mar 31, 2021

fubar57 · Mar 31, 2021

Looking forward to it

Airframes · Mar 31, 2021

Looks like a neat little kit - looking forward to seeing it come together. Always liked the look of this little bird.

fastmongrel · Apr 1, 2021

Made a pigs ear of fitting the instrument panel. I had it in the wrong place and I only spotted it when I tried the fit of the wing. Luckily the glue hadn't set hard so I was able to lever it out and fit in the correct spot.

Wurger · Apr 1, 2021

fastmongrel · Apr 1, 2021

Still got the instrument panel wrong. It's out now in 2 pieces waiting for all the joints to set hard. Then I will fit wing first then glue the panel to the wing.

Airframes · Apr 1, 2021

Hope you get it sorted.

fastmongrel · Apr 2, 2021

Okay third attempt to get the wing and instrument panel joint right. I have glued the centre instrument panel to the wing.

Wurger · Apr 2, 2021

fastmongrel · Apr 2, 2021

I have glued the instrument panel sides to the fuselage

Then I have glued the wing. There's a bit of a gap on the right but I can fill that with some sprue.

Only problem while holding the wing in place I have broken the left side landing gear leg

Wurger · Apr 2, 2021

fastmongrel · Apr 2, 2021

Too strengthen the legs I am going to fit 0.3mm brass wire rather than use thread to make the bracing wires.

That's better

Wurger · Apr 2, 2021

I have used a stretched sprue for both my old P-11c and P-7.

fastmongrel · Apr 2, 2021

All square now

Wurger · Apr 2, 2021

Arma hobby PZL P.7A in 1/72

1st Sergeant

Siggy Master

Marshal

1st Sergeant

1st Sergeant

Siggy Master

General

Benevolens Magister

1st Sergeant

Siggy Master

1st Sergeant

Benevolens Magister

1st Sergeant

Siggy Master

1st Sergeant

Siggy Master

1st Sergeant

Siggy Master

1st Sergeant

Siggy Master

Users who are viewing this thread

Similar threads