Crimea_River
Marshal
Thanks Geo. I don't use Vallejo paints anyway and have no reason to switch from my Tamiyas which I've used for years. The Tamiyas thin nicely with cheap IPA and clean up with it as well. My typical clean after each session is as follows:
1. Dump excess paint.
2. Fill cup with IPA and clean walls and inlet with a paint brush. Dump dirty IPA and repeat.
3. Fill cup with IPA and run through AB at 40psi until empty. Repeat.
4. Occasionally strip AB and clean metal parts thoroughly with lacquer thinner avoiding contact with the plastic seal on the nozzle. Clean that with IPA.
1. Dump excess paint.
2. Fill cup with IPA and clean walls and inlet with a paint brush. Dump dirty IPA and repeat.
3. Fill cup with IPA and run through AB at 40psi until empty. Repeat.
4. Occasionally strip AB and clean metal parts thoroughly with lacquer thinner avoiding contact with the plastic seal on the nozzle. Clean that with IPA.