ccheese
Member In Perpetuity
I know what Dan would say... "Jesus H. Christ-mas" !! Wonderful work,
Wojtek, we are truly amazed at your talent.
Charles
Wojtek, we are truly amazed at your talent.
Charles
Fw190A6 Sturmjager of Sturmstaffel1 (1 Viewer)
- Thread starter Wurger
- Start date
- Thread starter
- #342
Lucky13
Forum Mascot
*Speechless*
Airframes
Benevolens Magister
Fli...wha...cri...oomph....stutter....stagger....er....Good Grief!!!
Is there going to be ANY of the original kit left Wojtek?!! Fantastic work!
BTW, if you would like some unused, thin, aluminium printing plates, approx. 35 x 25 cm, to use for making templates, let me know. I have a small stash hidden away somwhere!
Is there going to be ANY of the original kit left Wojtek?!! Fantastic work!
BTW, if you would like some unused, thin, aluminium printing plates, approx. 35 x 25 cm, to use for making templates, let me know. I have a small stash hidden away somwhere!
- Thread starter
- #345
THX for all.
Terry I'll remember your offer.Thank you very much.
That's very kind of you.
Here the next shots.The inner surfaces of the lower half of the wing have to be make smooth as well if we want to put there a few elements that can be seen by the wheel bays.For that purpose I used an another scalpel razor and sand paper.
Terry I'll remember your offer.Thank you very much.
That's very kind of you.Here the next shots.The inner surfaces of the lower half of the wing have to be make smooth as well if we want to put there a few elements that can be seen by the wheel bays.For that purpose I used an another scalpel razor and sand paper.
Attachments
Lucky13
Forum Mascot
Soooo.....THAT'S where the sun is!
Oh, right....excellent work Wojtek!
Oh, right....excellent work Wojtek!
- Thread starter
- #347
A4K
Brigadier General
Great work my friend!
Airframes
Benevolens Magister
Beautiful work!
- Thread starter
- #350
THX
"The struggle" against the wheel bays continuation.....
As I told you these doors fitted to the bays of the wing model but these don't fit to drawings.I tried a couple of times to find their correct position but without any success.However I found that the front edge of bays could be a reference point for making correction.Then I compared the area with a door of a correct shape and all became clear.I started making corrections.
to be continued....
"The struggle" against the wheel bays continuation.....
As I told you these doors fitted to the bays of the wing model but these don't fit to drawings.I tried a couple of times to find their correct position but without any success.However I found that the front edge of bays could be a reference point for making correction.Then I compared the area with a door of a correct shape and all became clear.I started making corrections.
to be continued....
Attachments
Lucky13
Forum Mascot
Time for a beer Wojtek, time for many beers! Will it be ANYTHING left of the original kit when you're done?? Probably be a 1/48 Wurger Fw 190A-6....
- Thread starter
- #352
marek
Senior Airman
Great sergery, Wojtus!
A4K
Brigadier General
- Thread starter
- #355
marek
Senior Airman
A4K
Brigadier General
The pilot stepladders First step!
No, that's 0.286 mm too thick - he's making a new one from stretched sprue..
marek
Senior Airman
- Thread starter
- #359
Doin' great Wojtek!
