GB-64 1/48 P-51D ( II ) - One Trick Pony

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

Thanks guys. Spritzed Vallejo 77.706 White aluminum on the moving surfaces and the bottom. Hard to see in real life so I'll try to get a photo after it dries. Once dry, I'll gloss coat to prevent scratches
 
Picture taken, not very showy but it did show me one thing that I noticed in my editor. Flaps showed different reflections which means one is out of whack. Sho nuff, I went down and the left was about 2mm higher so some gentle persuasion corrected this. Battery died while correcting so you get the before....

IMG_3235.JPG

A little lesson I learned while spraying the Vallejo. If you previously used IPA to clean and flush Tamiya out of the AB, make sure you thoroughly flush all the IPA out. Vallejo really, really, really hates IPA
 
Great looking build, and one on my list as well. Along with Martin Kyburz on FB, and photos I found in the "Bob Hoover" collection in the San Diego Air Museum Archive...we can get a better idea of how this looked. Of interest is the "overnight" bag behind the armor plate. The photo of 025 was traced by Martin and it's final fate in Korea.

Jim
 

Attachments

  • IMG_9207.JPG
    IMG_9207.JPG
    142.4 KB · Views: 2
  • IMG_9206.JPG
    IMG_9206.JPG
    31.9 KB · Views: 2
  • IMG_9205.JPG
    IMG_9205.JPG
    101.8 KB · Views: 2
  • IMG_9204 (1).JPG
    IMG_9204 (1).JPG
    80.5 KB · Views: 4
  • IMG_9202.JPG
    IMG_9202.JPG
    62.4 KB · Views: 2
  • IMG_9203.JPG
    IMG_9203.JPG
    80.2 KB · Views: 2
Thank you O.D. spritzed

IMG_3237.JPG

I've made about six copies of the decal sheet. My plan is to cut the section out that goes above the exhausts and tape it into position. This will allow me to run a strip of masking tape along the upper edge of the paper to get the correct angle of the O.D.. The checker paint job was not along the thrust line but was at the same angle as the ground line; stupid ground crew. The blank spaces on the sheet are the white checkers in case one wanted to paint the area red. I'll use them in case the red and O.D. show through the decals as I suspect they will

IMG_3238.JPG
 

Users who are viewing this thread

Back