GB-64 1/48 P-51D ( II ) - One Trick Pony (3 Viewers)

[Vic Balshaw]

Perfect.

 

[Wurger]

Well done. Geo.

 

[fubar57]

Thanks guys. Doing the right side around the exhausts shortly and do the lower ones that wrap around the bottom later. I was worried about these two lining up but the picture shows the join is not perfect

 

[Gnomey]

Nice work so far George!

 

[fubar57]

Top checkers laid out, still a bit short but lined up with the O.D.. Placed the wing star and bar on as well. This being a bullet proof Tamiya decal, I poured the Walther's to it and will check in half an hour whether this was a good thing or not. I have plenty of spares

 

[Wurger]

 

[Vic Balshaw]

Your doing good George.

 

[fubar57]

Thanks Vic. I've never used this type of decal before. I assume I cut out the clear film in the cut-out and pray for the best? I tried it with a paper copy and it wasn't very promising

 

[Vic Balshaw]

If I'm right in thinking that 'V' gap would fit at the bottom over the air scoop, I would be inclined to cut that out hoping for a better fit. Can you see if the decal edge follows the 'V' or is it solid clear decal.

 

[fubar57]

Just got in from a 3km walk, -9°C. I'll go down and check shortly. Before I left I checked the wing decal. The flood of Walter's seems to be working

 

[fubar57]

Ok, went down and looked at the decal; clear film down to the pink arrow so Imma thinking I have to remove this.

​

The Walther's is working great. It was tented some what along the pink lines and is almost now flush along that fence or what ever it is

 

[Crimea_River]

I got nuthin' on those checkers. Praying sounds good.