GB-65 1/48 YF-4E Phantom - No Propellers

Good stuff Bill :thumbright:
 
So then I thought.................. nooooooooo
I can do a Decal shirely!
Took a few goes. When Outlining, the outline is partially Outside the image, annnnnd Inside.
So it Increases the width. 0.5mm outline = 0.25mm both Inside and Outside. Makes for 0.5mm fatter stripe.
Takes some fiddling and fitting. Color is another story. I can take a sample color from a jpeg!
However if the shot is in bright daylight, or in shade? See my dilemma. So I have taken a sample from a daylight photo.
Sample it, gives me a formula. Then over to SMS lacquer color samples. Now I have three blues to match the YF-4E scheme.
So the result, stripes, texts, patches and even non-standard Star and Bar. BTW, other kits have that same patch both sides, nah!
They are different, and now I gottem!!!!!! Got some Milliput coming I can start building in earnest!
GB65-8.jpg
 
:thumbright: :thumbright:
 
Well done Bill!
 
Funny man................. of course they are printouts of my finished drawing in Corel.
Below is the file off to be printed. There are a couple of added pieces for the Mustang.
Gear door crew list and new drawn to fit wing tip stripes for same!
B3X_GB-64-65 .jpg
 
Not a chance of finishing in time, but I have started sculpting the covers at the intake.
The covers had toe be vertical for the canards mounting. Plastic sheet on top, and sides.
Filling then sanding for contours front and back. Looks as messy as my Mustang!!!!!
GB65-9.jpg
 
Still a "little" rrrruffff! This part allllways takes the longest. Should never enter anything like this.
Fill, file, sand, file, sand some more,. Fill, again. File and sand................................. on and on.
GB65-10.jpg
 
Agree with the obsession coment..!
Great progress Bill.
 
Workable fillers........................ how many do we have to buy before finding a good one,
Apart from Mili-Put!!!!!
 
Back on this one to plug along.
Fitted the Conards was a bit of a struggle
finding a way to get the bits flat to set.
In the end I am showing my Method!!!!
It seemed to work.
GB65-13.jpgGB65-12.jpg
 

Users who are viewing this thread

Back