Robin Olds SCAT XXVII - Phantom F-4C

[Gnomey]

Nicely done so far!

 

[al49]

After some researches I understood that the long pylon should be correct for the model I'm making, so I went on adding the two fins and opening two little doors in the plane belly to replicate fin supports.
Alberto

 

[Wurger]

 

[Crimea_River]

Nice work Alberto.

 

[Wayne Little]

Nice...

 

[Gnomey]

Good work so far!

 

[SANCER]

Alberto, ...That tank is running luxury !!

Saludos
Luis Carlos

 

[Robert Porter]

Looks great!

 

[al49]

Hi everybody, back from my usual time on my holiday hose, I continued my work on this project.
Cockpit set, including seats is from GT resin.
Enclosed some pictures.
Any comment/suggestion is very welcome.
Thanks
Alberto

 

[Wurger]

 

[Crimea_River]

Nice work Alberto.

 

[SANCER]

It's good to see you back, Alberto. Those interiors and seats are "padrísimos" ("great").

Cheers

 

[fubar57]

Welcome back Alberto. Innards look great

 

[al49]

Many thanks for your nice comments!
Next step will be priming everything and then i think this build will be put on old for some time, because I want to finish at least two of the other models still w.i.p.
Alberto

 

[Airframes]

Very nicely done Alberto.

 

[Gnomey]

Lovely work so far!

 

[al49]

Beside my intention to put this build aside for a while and complete at least one of the other w.i.p., i did some more work, i.e. I added some pipes inside landing gear wells, no pictures, yet. But I also discovered an other shortcoming in the Tamiya kit: the ECM pod supplied isn't suitable for a 1967 bird because it's too new. According to what I learned this pod should be of QRC-160-1/ALQ-71 type. There was a Cutting Edge kit for that, but its very, very hard to find, so my question are, do you know any other source? Do you know where I could find a drawing so I could scratch-build it myself?
Enclose picture of ALQ-87, supplied with the kit and ALQ-71
Many thanks
Alberto

 

[Wurger]

Perhaps these can come in handy..

 

[al49]

That's great, thanks! And should be enough to make a suitable drawing, if I don't succeed in finding the Cutting Edge kit.

 

[Wurger]