Well if that little gremlin struck again she's not going to be ready for the show this W/E.I was building the tailwheel assembly a piece flipped out the fingers hit the chest and went under the desk on a hardwood floor and that's all it wrote.That little POS grabbed it up and off to his hole it went.The first pick is the factory the white part is what I had to make nothing hard just 30/45 more minutes even got the bolt heads with the punch.The next pic is the rockets and to get a decent crisp lines.I first glued a bigger diameter to my plate and beveled the inside of the tube to cover the light grey all the rockets had been painted in and then painted the green.The next step was to tape off the area below the white/grey for the bottom of the red stripe and got a smaller diameter tube beveled and glued it to the platform and sprayed the red.I think if will work still got some more brush painting but the jig worked.