Unofficial Bf 109-x GB: 1/72 Bf 109H-1 (3 Viewers)

[A4K]

Cheers guys.
Should be ok Vic... Has the usual MPM problem of thick trailing edges, but thankfully the mainplanes have been moulded in one piece, so only have to deal with that on the wing fillets. Opening the radiator flaps should sort that.

 

[Crimea_River]

Great progress Evan and Happy New Year to you as well.

 

[A4K]

Cheers mate.

 

[A4K]

Having fun removing ejector pin marks from tight spaces.

 

[Wurger]

 

[A4K]

Ahoj my friend

 

[Vic Balshaw]

Having fun removing ejector pin marks from tight spaces.
View attachment 755554

That was a nasty one Evan, well done.

 

[T Bolt]

Good one Evan

 

[A4K]

Cheers guys, second one almost finished now too.

 

[Wurger]

Ahoj my friend

Hi Pal.

 

[Crimea_River]

Them marks are a pain.

 

[A4K]

Yep. Too small a space for the carving blade too, so have to take small cuts off with the tip, then work them down with a pointed round file (normal file won't fit), finishing with a thin fibre-glass pencil and sandpaper... after that they need filling where the pin marks cut into the ribs, and to clean up my own cutting work.
You know, the usual.

Second nearly done.

 

[Wurger]

 

[A4K]

Filing back the cockpit rear section (port side done, working on starboard)

 

[Wurger]

 

[A4K]

Dzieki my friend.
Rear portion filed down and cockpit walls thinned to take PE sidewalls.
Each wall had an ejector pin mark like those fore and aft.
(Slight dip in rear section will be covered by PE panel)

 

[Wurger]

 

[Vic Balshaw]

Yep. Too small a space for the carving blade too, so have to take small cuts off with the tip, then work them down with a pointed round file (normal file won't fit), finishing with a thin fibre-glass pencil and sandpaper... after that they need filling where the pin marks cut into the ribs, and to clean up my own cutting work.
You know, the usual.

Second nearly done.
View attachment 755605

Not easy and so tedious.

Your working well Evan.

 

[A4K]

Cheers mate.

 

[Wayne Little]

Good job so far.....even if it's just getting bits prepped right....