1/72 ProModeller B-17G "2nd Patches"
- Thread starter
- #102
Thanks for that chart Geo, but unless I am not seeing something, the only specification I see for number of bands seems to be only for denoting the chemical gas bombs. I should have specified that I am looking for explanation of the yellow marked GP bombs.
Crimea_River
Marshal
Try this:
- Thread starter
- #104
fubar57
General
The last few pages have some more info, 25-29
- Thread starter
- #106
- Thread starter
- #107
Thanks to George and Andy, who set me straight with all the info I needed and then some, I have finished painting the bombs. Thanks guys!
The top two have only the base colors applied and the bottom two have received some light weathering. Though I have the information for it, I am not going to bother with the black stenciling since these will be tucked way up in the bomb bay. The picture makes them appear greener than they actually are, in person the color is a dark olive drab. I used MM Acryl Green Drab FS34086. The stripes were mostly applied by hand and a fine brush, as the lines were so small that when initially masked and painted the tape took most of the stripes with it. Probably would have been better with the masking if I had airbrushed instead of brush painting, but I couldn't be bothered by the clean up and such for a very tiny amount of paint. The stripes are Aeromaster US Interior Yellow.
Pictures of bombs I have seen show many of them with a streaky appearance due to rain and dust while stacked in the dumps. For this I drybrushed Aeromaster French Tan, very diluted flat black streaked on then immediately wiped off to achieve a darker stain then lightly dry brushed with the original green drab to even some areas out. The fins were not weathered since these were added just before loading into the aircraft. The fuse on the nose was painted Tamiya flat aluminum and everything given a wash of raw umber oils for another filtering layer.
Phew! I think it took me less time to paint these than to write out the explanation! More soon.
Chad
The top two have only the base colors applied and the bottom two have received some light weathering. Though I have the information for it, I am not going to bother with the black stenciling since these will be tucked way up in the bomb bay. The picture makes them appear greener than they actually are, in person the color is a dark olive drab. I used MM Acryl Green Drab FS34086. The stripes were mostly applied by hand and a fine brush, as the lines were so small that when initially masked and painted the tape took most of the stripes with it. Probably would have been better with the masking if I had airbrushed instead of brush painting, but I couldn't be bothered by the clean up and such for a very tiny amount of paint. The stripes are Aeromaster US Interior Yellow.
Pictures of bombs I have seen show many of them with a streaky appearance due to rain and dust while stacked in the dumps. For this I drybrushed Aeromaster French Tan, very diluted flat black streaked on then immediately wiped off to achieve a darker stain then lightly dry brushed with the original green drab to even some areas out. The fins were not weathered since these were added just before loading into the aircraft. The fuse on the nose was painted Tamiya flat aluminum and everything given a wash of raw umber oils for another filtering layer.
Phew! I think it took me less time to paint these than to write out the explanation! More soon.
Chad
fubar57
General
Looking good Chad
Good work so far!
- Thread starter
- #110
Thanks Geo and Gnomey!
Making some more progress.
The bombs are now in their racks.
Moving on to the radio room.
Not adding much detail here as the radio room is represented fairly well OOB. Painted up the radio units and table with acrylics and oil washes on the forward radio room bulkhead. The bottom picture is showing the wood shelves for the short range radios I scratched from scrap styrene. I may add some wires, still undecided.
The rear radio room bulkhead.
That's where I'm at right now. Researching the floor to get it painted up correctly any to add any details if necessary.
Chad
Making some more progress.
The bombs are now in their racks.
Moving on to the radio room.
Not adding much detail here as the radio room is represented fairly well OOB. Painted up the radio units and table with acrylics and oil washes on the forward radio room bulkhead. The bottom picture is showing the wood shelves for the short range radios I scratched from scrap styrene. I may add some wires, still undecided.
The rear radio room bulkhead.
That's where I'm at right now. Researching the floor to get it painted up correctly any to add any details if necessary.
Chad
Last edited:
Crimea_River
Marshal
Stunning.
SANCER
Senior Master Sergeant
Great inners Chad 
It seems that you are about to start putting the pieces together!
Saludos
It seems that you are about to start putting the pieces together!
Saludos
- Thread starter
- #113
Crimea_RiverThanks!
SANCERThanks L-C, I'm getting closer, sometimes it seems like it will never be finished, keep finding more stuff to add
Airframes
Benevolens Magister
Great stuff Chad, it's really looking the biz !
SANCER
Senior Master Sergeant
The same thing has been happening to me
Thanks L-C, I'm getting closer, sometimes it seems like it will never be finished, keep finding more stuff to add
, it seems that you are about to finish some stage, but you see, details or errors that can be improved, or simply improvise some "thing" not included in your kit. And it seems you will never end !! Your "Fortaleza Voladora" is looking great so far amigo mío
- Thread starter
- #116
SANCERYou are exactly right, and muchos gracias mi amigo! Below is more proof I can't leave well enough alone.
I decided the bomb bay needed some attention, so I added some wiring and plumbing with lead and copper wire and some pieces of styrene. This is before painting. Also notice I made the receptacles on either side of the door bottom for manually lowering and retracting the landing gear and bay doors. I tried to hand paint the stencils above these.
And after careful detail painting and raw umber oil wash.
The bomb bay is finished and sealed up! Closing the fuselage is inching closer. Still have to tackle the dorsal and ball turret before that though.
And guess what?
I decided to add wires to the radios afterall. Also added another shelf for the equipment above the left radio.
That's all for now. Thanks all of you who have been following along with me, you guys keep me motivated to keep going.
Chad
fubar57
General
Lordy.............
Airframes
Benevolens Magister
Excellent !
Great work so far!
ArmouredSprue
Senior Airman
Beautiful work so far. Keep it up!
