Straightening the horiz stab for the elevators. Using a piece of tile edge finishing angle.
Rounding the pivot side of the rudder pieces, middle one done already.
Two rudder pieces to go, and the elevators.
Work work work.
Thanks for the comments, they are appreciated. But.........
I've had a slight mishap. A biga$$ crack developed in the wing as I was doing some aileron and flap work.
I've had to do an amputation, and now a splice...... not difficult but fiddley.
Fortunately the underside of the top wing part is dead flat. I've attached a piece of .5mm card to the tip section and clamped it in place to set.
I'll have to insert a wedge to keep it tight against the wing center section to get a good join. Should work! Fingers crossed.
Not the most difficult thing I have done.