Brushable surfacer/primer

[fastmongrel]

I am looking for a surfacer micro filler that can be hairy stick brushed on and isn't too toxic. Basically a non pongy version of Mr Surfacer which smells like a chemical works and seems to hang around for ever.

Does such a thing exist.

 

[Crimea_River]

I use Tamiya's Grey Surface Primer. It's lacquer based but doesn't smell. I spray for large areas and use it with a brush to spot-fill defects, recessed panel lines and rivets. Several dabs are usually required to fill a typical panel line. I have not tried brushing over larger areas.

 

[fastmongrel]

How thick is it. I know it's a very subjective experience but would it be as thick as say unthinned Tamiya paint out of the jar.

 

[Crimea_River]

It's thicker than the paint but, like I said, it won't fill a panel line in one pass. It usually takes 2 or 3 but I've built up the coats as it dried so I don't necessarily wait for it to dry. Once dry (6 or more hours - I usually let it sit over night), I sand it back.

 

[fastmongrel]

I have just checked to see how much it would cost. It's not available in Britain and would cost £23 to get it sent from France

 

[Airframes]

I've normally used just an enamel paint ( normally Humbrol ) in a light grey matt finish. Once brushed on, it can be lightly sanded to give a smooth surface and a good "key" for the finishing coat(s).
For filling, mix in a little talcum power and brush onto the panel line /divot / sink mark or whatever, let it harden, and lightly sand back.
Cheap, easy and effective.

 

[Wurger]

With Terry. I use the same.

 

[fastmongrel]

We have just gone back into lockdown in Britain and most shops are shut but next time I do the food shopping I shall get some talcum powder and have a go.

 

[Airframes]

Good stuff.
Mix the talc into the paint to create a thick, but fluid mix, rather like porridge. Use an old brush to brush onto the surface, and "lay off" as required.
I normally leave this at least 12 hours, to ensure it's fully hardened, before sanding.

 

[vinnye]

Just found this on Ebay, would this be any good?
Tamiya 100ml Grey Surface Primer # 87026/* | eBay

 

[fastmongrel]

Just found this on Ebay, would this be any good?
Tamiya 100ml Grey Surface Primer # 87026/* | eBay

I think thats the aerosol. Its the brushable stuff in a jar that isnt available in the UK as far as I can tell.