Dazzled 1/48 NA-91 / P-51A? kit

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

So now the kit landing light hole is filled, sanded and primed.
This one shows my bottle of Sprue melted at the bottom of the bottle of Acetone.
It is rather fluid, but more like soft butter. I use the S.S. mixer to extract it from the jar.
It will not stick to the steel so can be testy to get it out. But can be spread very thin like Bondo.
Let it dry many hours, over night would be best as even this thin it takes some time for the Acetone to evaporate.
I filed first, then sanded smooth. I also scribed new panel lines.
P-51A Dazz 21.jpg

And here is the result after priming with a white coat. The under side of the wings will be white with black dazzle.
The new landing light lense is next to the cannon. Gear doors are stuck with blue tac only for painting & masking.
P-51A Dazz 22.jpg
 
Painted the underside of the wing today.
Cut masking for the same, the process!!!!!
From my artwork I printed full scale.
The orange will be painted black.
The blue is a piece of Tempered or as it
is called over her Toughened, samo samo.
I put 3/4" tape on the glass then taped
the printed pattern over. Using a new X-acto
blade I cut along the edges of the Orange,
then the printed edge of the wing outline.
P-51A Dazz 23.jpg
I then removed the cut-up pattern pieces
and picked out what was orange. These
pieces will mask the white first coat and
I will spray the black. I'll be doing the same
for the sides of the fuselage. Wing and
fuselage will be painted Before I attach
the wing to the fuselage. Top is already O.D.
P-51A Dazz 24.jpg
It goes on and on..................
 
Thanks for looking in on this unusual build. Masking? Yikes!!!! It's been a bit of a chore.
The underside of the wing is now ready for paint. There is some seams work to be done on the
fuselage. The edges are not that square and flat!! It goes on and on.
P-51A Dazz 25.jpg
 

Users who are viewing this thread

Back