So I have done some additional stuff on the bulkheads internally,
yes, it will never be seen!!!!
So now on to the Sonar operators station......
Done the box for the transducer cable reel.....
now on to the reaal Hard part,
the seats. Pulling this off will be tough!
the seat and back are only the start!!!!
I got a bit sidetracked, with the interior again.
Removed the ducting from the interior sidewalls,
since I'm going to pad the walls,
and attached them to the overhead piece, since the ducts will be visible above the padding.
The padding is a quilted sound proofing blanket to lessen the noise for the Sonar operators.
It will all come clear. I did padding on the SH-3A for an earlier GB.
Thanks guys, there is more.
The mesh PE didn't fit very well;
So I enlarged the recessed area for the mesh to fit.
The opening does Not span both doors, there is sheet metal at the end. So I stuck a piece of
styrene across the opening..........
Then shaped it's profile to the door.
Much better. I'll recess that too.
Thanks for the kudoes guys.......
So tody did some masking and painting on the F4, drying time lets me work on thissun!
Painting bits like the upper deck of the transmission area and engine, fiddley bits!
Hadn't realised I'd done so much, woohoo.