- Thread starter
-
- #81
N4521U
Colonel
So looking at the exterior I notice there is a step just above the gear strut.
But of course, I just have to build them, one each side.
And add some piping! It's not attached yet. There is a hand hold next to it I will use wire.....
Ive done a bit of engine painting and assembly, wire piping is next.
But of course the screens are not correct.
The top one next to my finger does Not form to the bend, it's above it on the straight.
The one at the back is also sarrower, and higher.
Above and below That vent screen is a cut out hand hold for swinging the tail to the stowage position.
I will change this!!
Clearance lights as well are not as in the kit!
It goes on and on.
But of course, I just have to build them, one each side.
And add some piping! It's not attached yet. There is a hand hold next to it I will use wire.....
Ive done a bit of engine painting and assembly, wire piping is next.
But of course the screens are not correct.
The top one next to my finger does Not form to the bend, it's above it on the straight.
The one at the back is also sarrower, and higher.
Above and below That vent screen is a cut out hand hold for swinging the tail to the stowage position.
I will change this!!
Clearance lights as well are not as in the kit!
It goes on and on.