- Thread starter
-
- #121
dneid
Staff Sergeant
Ok, finally down to those pesky fiddly bits. First issue is the mounting pins of the forward gear bays. Try as I might to be extremely careful in cutting out the excess plastic between those door mount pins, I did break one off on one door. I cut the other one away and made a replacement out of a B-string from a heavier set of guitar strings. I was able to drill two holes for them in the edge of the door and got them mounted. I did clean up the excess epoxy as seen in the picture az well as touched up the RLM02. Both doors are now mounted and the fiddly bit work starts in earnest now.
Last edited: