About an hour of bench time today. Scratched up some lap belts using wine bottle foil and added the hand grips. For the belts, I had a spare Eduard PE spring clip and strap and so used that instead of making one.
The shoulder belts have now been scratch built and added.
I also added an oxygen hose made of solder seen here just behind the joystick. Note also the ball bearing that Tamiya provides for a balance weight. Though it can be trapped in the part provided, it rattles around a bit so I made sure there was plenty of CA holding it in place.
Thanks again for popping in for a look and for the comments.
:eyeroll: ok for some... (he says, kicking his feet on the ground in envy)... I hope you're putting as much care, detail and attention into that Mossie as you do your models.