**** DONE: GB-51 1/48 MiG-21PF - No Propellers (1 Viewer)

Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules

Thanks all, Nice kit but as per Eduard, lots of fiddly bit to get the job done. Even so a pretty quick build to go together with a couple minor setbacks.
Worked on the main gear bay and the wing as well as the aft fuselage this morning.
First I had to add piping and a few other items to the main gear wells.
20210926_092644.jpg
20210926_092657.jpg
20210926_092702.jpg
20210926_092710.jpg

Then various ram air inlets around the aft fuselage, same items on both sides.
20210926_100405.jpg
20210926_100419.jpg

Then back to the main gear well to add bottles.
20210926_103158.jpg

And last but not least the lower wing to fuselage. as well as some of the upper forward fuselage items forward of the cockpit.
20210926_103742.jpg



It's starting to do the MiG thing!!!!
 
Thank you all for the kind words. Today I feel Irish and so green arrows will do.
Clean up work. when the wing was installed it was like there was a warp somewhere. The back of the wing would fit or the front mate would work but not both. In fact the right would fit or the left. I had to fit one side and let it dry, in fact front rt and then front left and then aft and clamp and cuss. It left a gap in the back and a step in the front despite mu better efforts.
20210928_134145.jpg

Then the forward section would align on one side or the other. this wan not as bad as the bottom was but still required Mr surfacer 500. There was a bit of clean up on the upper front where the pitot will mount.
20210928_134154.jpg

The step was on the forward wing to fuselage mount. the Mr Surfacer 500 was I shall say troweled on in this area but the other side the step is to the aft.
20210928_135029.jpg

I have to decided to use a thin strip of plastics to fill this step. I hope it will sand down with out too much issue.
20210928_135147.jpg

On the right aft section of the mate I had a gap, but not on the left. Again I used thin plastic stock to fill this gap. And lots of green arrows!!!!!!!!
20210928_135203.jpg
 
Premiered, I used a flat black primer as this is to be a very dull aluminum jet. I hope it works.

20210929_200443.jpg
20210929_200500.jpg
20210929_210849.jpg
 
I masked off the tail to shoot stainless steel and steel colors for the tail. Also found that all that nasty fighting getting the forward fuselage to go together cased a nasty row in the bottom and had to use to filler.

20211002_142827.jpg
20211002_142829.jpg
20211002_142841.jpg
20211002_142844.jpg
 
Last edited by a moderator:

Users who are viewing this thread

Back