**** DONE: GB-55 1/72 P-51D Mustang - MTO III

[Vic Balshaw]

What a pain and the best of luck, I'm sure it will come good. Like the red, looks nice and fiery.

 

[Gnomey]

Good work so far!

 

[PlasticHero]

Came out really well!! There are a few small chips like the OD above the exhaust that should be no problem.

 

[Vic Balshaw]

Looking good.

 

[Wurger]

 

[Donivanp]

Well done

 

[fubar57]

Agreed

 

[Crimea_River]

Good work on a tricky masking job.

 

[Gnomey]

Nice work so far!

 

[Wayne Little]

Good stuff.

 

[PlasticHero]

The metal re-re spray at the starboard exhaust area and tail area came out fine. I didn't get the yellow stripe on the gear door quite lined up; but will look ok on the flight line.

I'm going to do the rest of the decals and the basic panel line shading with the parts in this state. I expect to do some touch up when everything gets glued together. The sharp eyed among you have noticed that I'm using a new background. Dropped the air compressor onto the blue stage and smashed a hole through the middle of it. Nothing else was damaged.

 

[fubar57]

I like it!!! I use 28"x22" poster board for backdrops, very cheap. I use four as the backdrop colour affects the subject. These were shot using the same camera setting

 

[Vic Balshaw]

Going to be a nice looking Mustang.

 

[Jock Tamson]

Looking great

 

[le_steph40]

Nice !

 

[Gnomey]

Good work so far!

 

[Crimea_River]

Liking that.

 

[Wayne Little]

Scrubbing up alright....!

 

[PlasticHero]

I am really impressed by the decal stencils that Airfix provide.

That is 5.5 mm for my overseas friends. I had to take this by holding my jewelers loupe up to the camera lens.

 

[SaparotRob]

That's impressive!