**** DONE: GB-68 1/48 Fw-190A-8 - We all build Fw 190

Nice work Andy
 
Seams look great

From where you are, yes. :lol:

There is some misalignment, even after all this.
 
Thanks guys.

One unintended consequence of gluing the gun covers on at this stage is that the wing uppers will not fit onto the fuselage if attached to the bottom half. As a result, I've had to glue the uppers to the fuselage first, which had the added benefit of being able to make sure the seam is as clean as possible. The patient is in traction as we speak:

View attachment 859629

Fingers crossed that the lower half will go on smoothly but I see no reason why not. Thanks for stopping by.
I glued the lower wing to the fuselage first, then the uppers, sliding the gun hatch into the side of the fuselage as I did. The wings fit together beautifully, so I don't think you will have a problem there. My problem was the gun hatch to the fuselage joint, but it looks like you have that one solved.
 
👍🏻👌🏻👏🏻🏆
 
Thanks guys. So here are the warts.

Gun cover on the stbd side with smoothing work begun to remove the step:

25121201.jpg


The port wing halves didn't cooperate on mate-up but this is a small price for having a good wing to fuselage seam. This has since been rectified by filing and sanding.

25121203.jpg


Tail feathers were glued on. I like using the grid on my cutting mat to eyeball the alignment of the tail and main wing dihedrals from head-on so nothing goes wonky.

25121202.jpg


I'll post more when I get something worth showing. Thanks for following along.
 
Looking good Andy :thumbright:

I also line things up on the cutting mat grids.
 
Doin good Andy.
 
Fair enough Wayne. A small amount of work was actually done in the week before Christmas. The wing misalignment mentioned in the previous update was fled and sanded smooth. Then I fitted the engine and forward cowl. Ailerons were also added but I had to add a small bit of card to one edge to account for that wing misalignment issue. No pics of this latter stuff yet.

The engine and front cowl went in OK. I deliberately left off the guns until I tackled the gun cowl as I suspected there would be complications. In the below pic, there is a small lip just over the exhaust opening which was fixed with a bit of CA glue and clamping force.

25122302.jpg


Trial fitting the gun cowl, even without the guns installed, revealed that there was no way it would fit as the ammo chutes interfered and prevented the cowl from sitting down. I therefore lopped them off omitted the guns altogether. Even so, I had some challenges and fitted the cowl over two days, first gluing and clamping one side until cured and then tackling the other. There was a very slight twist in the assembly that I had to deal with but offset clamping helped to solve this. The cowl hinges don't quite line up but the priority was to get the seam as clean as possible. I'll deal with the hinge later.

25122301.jpg


Oh, and the inner cannon barrels didn't survive after all so I snapped them off and will replace them with brass rod toward the end of the build.

I'm not sure when I'll get back to the bench with several other projects taking priority but will post updates when they happen. Thanks for looking in.
 
:thumbright:
 

Users who are viewing this thread

Back