Ad: This forum contains affiliate links to products on Amazon and eBay. More information in Terms and rules
Andy, if you want to stop at that point for a while....Thanks guys. The following shot shows a few things on the go. Starting at top left, the two cowl fillers have been smoothed down and a bit of Tamiya grey primer dabbed on. At top right, the incorrect panel lines on the nacelles that were filled with primer a while back have been sanded. And in the foreground is the start at my attempt to widen the carb intakes
View attachment 698022
Lots more plastic dust to come.
I never doubted itThanks Yves but I'm actually enjoying the challenge of modifying the kit parts.
This may help you: I measured the original part of my Academy-clone and the front of the intake is 10.4-10.5mm wide.....Not bad for a first pass. More a'fillin' and a'sandin' ahead. Thanks for the look.
D'oh! I'm at 9.5. Will need to investigate that, thanks.This may help you: I measured the original part of my Academy-clone and the front of the intake is 10.4-10.5mm wide.
Don't know what's the exact width of the original intake 1:1 though.
Cheers!